Field NotesClassroomNo. 22

Teaching the plant life cycle with Fast Plants: seed to seed in about 40 days

Fast Plants go from seed to harvestable seed in about 40 days under lights. Here is the timeline by day, what students measure at each stage, and how to pollinate, harvest and plant the next generation.

A honeybee dusted with pollen on a small yellow four-petaled flower

The short answer Wisconsin Fast Plants, a rapid-cycling Brassica rapa developed at the University of Wisconsin-Madison, produce harvestable seed about 40 days after planting in ideal conditions, under continuous light. Students can watch germination (days 1 to 2), flower buds (from about day 9), flowering and hand pollination (about days 14 to 17), pod growth and seed dry-down, then plant the seed they harvested right away.

That is a full life cycle, seed to seed, in roughly six weeks, with numbers attached to every stage. Unit planning, growth standards and claim-evidence-reasoning writing are covered in how to build a plant science lesson plan. This note is the life cycle lab itself.

Why Fast Plants fit one grading period

The program says Fast Plants were developed at UW-Madison through artificial selection and bred to have “a uniform, short flowering time (14 days).” Three traits matter here:

  • Speed. Under ideal conditions of continuous light, water and nutrition, plants produce harvestable seed about 40 days after planting. A peer-reviewed teaching paper by Wendell and Pickard gives 35 to 45 days for the full cycle.
  • No dormancy. Dormancy was bred out “to make their life cycle faster,” so fully mature seed can be replanted immediately.
  • Students do the pollinating. The plants are typically self-incompatible: “an individual plant will reject its own pollen” (Wendell and Pickard). Seed depends on pollen moving between plants, and in a classroom that means students.

The cost is lighting, which Wendell and Pickard call the plants’ “only unusual requirement.”

Setup, care and safety

The program’s FAQ gives these conditions:

  • Light: intense and continuous, 24 hours every day, from cool white fluorescent or full spectrum LED lights about 3 to 10 cm (roughly 1 to 4 inches) from seedling tops for the first two weeks after germination. A windowsill gives spindly stems, small leaves and little or no flowering. Classroom grow light setup covers fixtures.
  • Temperature: about 70 °F. Cooler rooms slow growth. Warmer rooms speed it, but plants may become weak or spindly, and temperatures above 85 °F can harm developing seed pods.
  • Water: a wicking-type system. Never let seeds or plants dry out; check daily and top off reservoirs, especially before weekends.

For soil, Wendell and Pickard used potting soil “fertilized with commonly available house plant fertilizer.” Follow the label rate.

Count forward on a calendar so days 13 to 17 (the pollination window) don’t land on a long break.

Before day 1, check soil, pollen, latex and bee allergies with your school nurse. Offer non-latex gloves, and have everyone wash hands after handling soil and after pollinating. Students with pollen allergies can take the recording job on pollination days. Clear 24-hour lighting with your school, and keep cords and power strips away from reservoirs.

The life cycle, stage by stage

Day ranges and stages come from the program’s Grow page (the last row from its Harvest page), counted from planting. They assume ideal conditions; cooler rooms run slower.

Days after planting What happens What students record
1 to 2 Germination: the seed takes up water and swells until its seed coat cracks Planting date, seeds per pot
3 The hypocotyl (stem) pushes through the soil, pulling up the cotyledons (seed leaves) Seedlings up per pot
4 The hypocotyl lengthens toward the light First height
5 to 8 True leaves grow from the top of the plant; root hairs absorb water and nutrients Height, true leaves
9 to 13 Around day 9 the plant shifts to flowering; buds form at the growing tip Day of first bud, height, true leaves
14 to 17 Flowers bloom; pollen on another flower’s pistil grows a tube down to the eggs Day of first open flower, open flowers, pollination dates
18 to 20 Fertilized eggs become embryos; the pistil swells into a pod holding several seeds Pods per plant
21 to 40 Petals fall; seeds mature and must dry completely before planting or storage Date taken off water
About 40 on Plants and pods turn brown and crispy Pod length, seeds per pod, seeds per plant

The program’s Pollination page starts its window at day 13, a day earlier than the Grow page, so check for open flowers from day 13.

What students measure and how to record it

Measure the same plants on fixed days, such as Monday, Wednesday and Friday. Label plants by group number, pot and position, never by student name.

  • Height (mm): ruler from the soil surface to the growing tip. How to measure plant growth covers technique.
  • True leaves: count only leaves that grew after the cotyledons.
  • Days to first bud and first flower: the day number each is first seen. Agree as a class what “open” means.
  • Open flowers: count per plant on each pollination day.
  • Pods per plant: count pods that swell after pollination.
  • Pod length and seeds per pod: at harvest, measure each dry pod in mm, then crush it and count its seeds. Seeds per plant is the total.

Use two sheets. The growth sheet has one row per plant per measuring day (day after planting, plant ID, height, true leaves, notes). The reproduction sheet has one row per plant: first bud, first flower, pollination dates, pods, then each pod’s length and seed count. The teacher resources page has a printable data sheet to adapt.

Hand pollination

“Fast Plants® do not self-pollinate,” says the program’s Pollination page. The FAQ adds that their pollen is “heavy & sticky” and “not easily carried by wind,” though some pollination can happen through plant-to-plant contact or insects. In class, students carry the pollen.

The program’s tool is the bee stick:

  1. Use a whole bee or just its fuzzy thorax, with or without wings.
  2. Glue the thorax to a toothpick and let it dry overnight. Make sticks one or two days ahead.
  3. Soften brittle bees overnight in an airtight container with a little moist paper towel.

Bees have “plumose (branching) hairs” that capture and transfer pollen. A cotton swab, pipe cleaner or pollination wand also works, though the program recommends bee sticks for maximum seed production. Make the bee sticks yourself, and give swabs to students with bee allergies and to anyone who would rather not handle a dead bee.

Brush the bee over open flowers, passing pollen among different plants. To maximize seed, the FAQ recommends pollinating every day or every other day as flowers open over the 3 to 5 days after flowering begins. Each stigma is receptive for 2 to 4 days, depending on temperature, and a single pollination done with care will result in fertilization. Record each plant’s pollination dates and tool.

Dry-down, harvest and the next generation

Seed pods mature about 20 days after pollination, depending on temperature. Take plants off water (remove the reservoir) on the 20th day after the last pollination: if that was day 17, stop on day 37. Seeds finish maturing as the plants dry.

Harvest only when plants and pods are brown and crispy. In the FAQ’s words, “If your seeds are green, STOP.”

  • For a group harvest, cut pods into a paper bag and crush them. For seeds-per-pod data, harvest pods one at a time.
  • Pour seed and chaff into a shallow tray, pick out large pieces and gently blow the chaff away. The program suggests doing this outside.
  • Store clean seed in a labeled envelope inside a zipper-type sandwich bag in a refrigerator, with silica gel for 12-month storage. The program says seed stays viable for many years this way.

Mature seed can be replanted immediately (only the program’s Rosette-Dwarf seed needs extra time). With no dormancy, seeds “imbibe water at the first chance,” so keep drying plants and stored seed dry. Record generation two on the same sheets and compare offspring with parents.

Optional investigations

  • Does pollination effort change seed count? Pollinate some plants once and others every day or every other day, with the same tool. Count pods per plant, seeds per pod and seeds per plant. The FAQ’s note that one careful pollination will result in fertilization, and its advice to pollinate often to maximize seed, give students two predictions to test. Keep the groups apart, since plant contact can move pollen.
  • Which tool gives the most seed? Compare bee sticks, cotton swabs and pipe cleaners against the program’s recommendation.
  • Do longer pods hold more seeds? Plot pod length against seeds per pod for every pod the class harvests.

A single pod or plant can mislead, so compare means and ranges across several plants.

Where it fits in NGSS

The closest fit is MS-LS1-4: “Use argument based on empirical evidence and scientific reasoning to support an explanation for how characteristic animal behaviors and specialized plant structures affect the probability of successful reproduction of animals and plants respectively.”

Its clarification lists “transferring pollen or seeds” as an animal behavior that affects plant reproduction, and “flower nectar and odors that attract insects that transfer pollen” as plant structures. The core idea: “Plants reproduce in a variety of ways, sometimes depending on animal behavior and specialized features for reproduction.” A student with a bee stick plays the animal, and pollination-effort data is the evidence. The crosscutting concept suits seed counts: “some cause and effect relationships in systems can only be described using probability.”

Sources

  1. Grow Wisconsin Fast Plants | Everything you need to growWisconsin Fast Plants Program, University of Wisconsin-Madison
  2. Frequently Asked Questions - Wisconsin Fast Plants®Wisconsin Fast Plants Program, University of Wisconsin-Madison
  3. Pollination - Wisconsin Fast Plants®Wisconsin Fast Plants Program, University of Wisconsin-Madison
  4. Harvest Wisconsin Fast Plants Seed | When & how to harvest viable seedWisconsin Fast Plants Program, University of Wisconsin-Madison
  5. MS-LS1-4 From Molecules to Organisms: Structures and ProcessesNext Generation Science Standards
  6. Teaching Human Genetics with Mustard: Rapid Cycling Brassica rapa (Fast Plants Type) as a Model for Human Genetics in the Classroom LaboratoryCBE Life Sciences Education (Wendell and Pickard, 2007)

General information, not professional advice for a specific plant or crop. Spot something wrong? Email info@terrathink.io.

Keep reading

All field notes

Join the waitlist

New field notes by email, and first word when the hardware goes live.

By joining, you agree to get email updates from Terrathink. Unsubscribe anytime. Privacy policy