ToolsCalculator
Dew point calculator
Enter the temperature and humidity at your plants. The calculator finds the dew point: the temperature at which water starts to condense on a leaf, a window or a greenhouse roof.
The short answer Dew point is the temperature air must cool to before it is saturated and water starts to condense. A leaf, window or greenhouse roof at or below that temperature gets wet. The calculator works it out from air temperature and relative humidity, using the FAO crop water guide’s vapor pressure equation solved for temperature.
How to use it
Enter the air temperature (°F or °C) and relative humidity (RH) at canopy height, close to the leaves and shaded from sun or a grow light. For sensor accuracy, see how to choose a hygrometer.
To check a surface (a leaf, the inside of a window, a tent wall or a pot), add its temperature in the same unit; an infrared thermometer can read it. Check in the evening and around sunrise, when cooling air brings condensation.
You get the dew point in °F and °C; the spread, air temperature minus dew point (the National Weather Service, or NWS, calls it the dew point depression); the actual vapor pressure (ea) in kPa, as in the VPD calculator; and, for a surface, whether it is at or below the dew point (water will condense on it) or how far above.
What dew point tells you
The NWS defines dew point as “the temperature to which air must be cooled in order to reach saturation,” assuming pressure and moisture content stay the same. A higher dew point means more water vapor in the air. Dew is moisture that condenses on objects that have cooled below it.
Relative humidity is the actual vapor pressure divided by the most the air could hold at the same temperature, so it changes with temperature even if no water comes or goes. Dew point depends only on the water vapor present, so it holds steady as air warms or cools, until water is added or removed.
Vapor pressure deficit (VPD), saturation minus actual vapor pressure, tells you how hard the air pulls water from leaves; dew point tells you how cold a surface must get before water lands on it. At the dew point, RH is 100% and VPD is zero. What is VPD? covers the drying side.
The formula
With temperature (T) in °C:
- Saturation vapor pressure, in kPa:
es = 0.6108 × exp(17.27 × T / (T + 237.3)) - Actual vapor pressure:
ea = es × RH / 100 - Dew point:
Td = 237.3 × ln(ea / 0.6108) ÷ (17.27 − ln(ea / 0.6108))
es is the saturation vapor pressure (the most water vapor air can hold at T), exp means e (2.7183) raised to the power in parentheses, RH is relative humidity in percent, ea is the actual vapor pressure in kPa, ln is the natural logarithm, and Td is the dew point in °C.
Step 1 is equation 11 of FAO Irrigation and Drainage Paper 56, as in the VPD calculator. FAO doesn’t print step 3. It goes the other way, stating that “the actual vapour pressure (ea) is the saturation vapour pressure at the dewpoint temperature” (equation 14). Step 3 is equation 11 with ea in place of es and Td in place of T, solved for Td.
Worked example (made-up numbers): a small greenhouse at night, 59°F and 90% RH.
- T = (59 − 32) × 5/9 = 15°C.
- 17.27 × 15 ÷ (15 + 237.3) = 259.05 ÷ 252.3 = 1.0268.
- es = 0.6108 × exp(1.0268) = 0.6108 × 2.792 = 1.705 kPa, matching FAO’s own figure for 15°C.
- ea = 1.705 × 0.90 = 1.535 kPa (rounded).
- ln(1.535 ÷ 0.6108) = ln(2.513) = 0.921.
- Td = 237.3 × 0.921 ÷ (17.27 − 0.921) = 218.55 ÷ 16.349 = 13.37°C, or 56.1°F.
- Spread: 59 − 56.1 = 2.9°F (1.6°C).
- A leaf at 57°F is 0.9°F above the dew point, so by the numbers it stays dry (see sensor error below). Glazing at 50°F is 6.1°F below it and will be wet.
Warm that air to 68°F (20°C) without adding water and es rises to 2.338 kPa, so RH falls to about 66% (1.535 ÷ 2.338), but the dew point stays at 56.1°F.
Why it matters for plants
UMass Extension describes the greenhouse cycle: “At night as the air cools to the dew point, condensation occurs and water droplets are formed on cooler surfaces such as the leaves and glazing.” Single glazing condenses more than double glazing because it reaches the dew point sooner. In the UMass example, at 60°F and 85% RH, water condenses on a leaf colder than 55°F; the calculator gives 55.5°F. A cold window or a tent wall in a cool room follows the same rule.
Wet leaves favor disease:
- Botrytis blight. UConn Extension says spore germination and infection generally depend on a film of moisture for 8 to 12 hours, RH of 93% or more, and 55 to 65°F. UMass notes that condensation promotes germination of Botrytis spores.
- Basil downy mildew. UConn says the pathogen needs at least 4 hours of leaf wetness and at least 85% humidity in the canopy to infect, and more than 7.5 hours above 95% RH at night to produce spores.
What growers do about it
- Keep air moving. UMass says air movement is adequate “when the leaves move slightly”; the mixing keeps air at the leaf surface from cooling below the dew point. UConn cites an Israeli study in which nighttime fans suppressed basil downy mildew.
- Heat and vent two or three times an hour after sundown and again at sunrise, replacing moist air with drier outside air (UConn, UMass). It works even in cool rain: UMass notes that 50°F air at 100% RH holds about half the moisture of greenhouse air at 70°F and 95% RH. Bottom heat also helps prevent condensation on leaves (UMass).
- Water in the morning, so leaves dry before evening (UConn, UMass).
- Give plants room. Wider spacing and open mesh benches improve airflow (UMass, UConn).
How sensor error carries into the dew point
The WMO instruments guide notes that when dew point is calculated from RH and temperature, a 0.1 °C error near 20 °C (68°F) has the same effect as an RH error of 0.6% of the reading.
In the worked example, a hygrometer 3 points high or low (93% or 87%) gives a dew point of 57.0°F or 55.1°F. A thermometer 1°F off shifts the dew point about 1°F the same way; the spread barely changes, but the surface check, which uses a separately measured surface, does. Either error could put that 57°F leaf at the dew point, so treat a margin of a degree or two as too close to call.
Sources
- Chapter 3 - Meteorological dataFood and Agriculture Organization of the United Nations (FAO Irrigation and Drainage Paper 56)
- NOAA's National Weather Service - GlossaryNOAA National Weather Service (entries: Dew, Dew Point, Dew Point Depression)
- Reducing Humidity in the GreenhouseUMass Extension Greenhouse Crops and Floriculture Program (John W. Bartok, Jr.)
- Botrytis blight on Greenhouse CropsUConn Extension Integrated Pest Management Program (Pundt, revised 2023)
- Downy Mildew on Basil in the GreenhouseUConn Extension (Pundt and Allen, revised June 2024)
- Chapter 4. Measurement of humidityWorld Meteorological Organization, Guide to Instruments and Methods of Observation (WMO-No. 8), Volume I, preliminary 2018 edition
Estimates for general guidance, not professional advice for a specific plant or crop. Spot something wrong? Email info@terrathink.io.


