ToolsCalculator
VPD calculator
Enter the temperature and humidity at your plants. The calculator works out the vapor pressure deficit: how hard the air is pulling water from the leaves.
| Temperature | 30% | 40% | 50% | 60% | 70% | 80% | 90% |
|---|---|---|---|---|---|---|---|
| 60°F 15.6°C | 1.24 | 1.06 | 0.88 | 0.71 | 0.53 | 0.35 | 0.18 |
| 65°F 18.3°C | 1.48 | 1.26 | 1.05 | 0.84 | 0.63 | 0.42 | 0.21 |
| 70°F 21.1°C | 1.75 | 1.50 | 1.25 | 1.00 | 0.75 | 0.50 | 0.25 |
| 75°F 23.9°C | 2.07 | 1.78 | 1.48 | 1.19 | 0.89 | 0.59 | 0.30 |
| 80°F 26.7°C | 2.45 | 2.10 | 1.75 | 1.40 | 1.05 | 0.70 | 0.35 |
| 85°F 29.4°C | 2.88 | 2.47 | 2.05 | 1.64 | 1.23 | 0.82 | 0.41 |
| 90°F 32.2°C | 3.37 | 2.89 | 2.41 | 1.93 | 1.44 | 0.96 | 0.48 |
The short answer VPD is how much water vapor the air could hold at its temperature minus how much it actually holds. This calculator uses the Tetens equation from the FAO crop water guide. Orchid and greenhouse guidance often cites about 0.5 to 1.2 kPa as a middle band, but the right number depends on the plant and its stage.
How to use it
Measure air temperature and relative humidity where the leaves are: at canopy height, close to the plants, and shaded from direct sun or a grow light. Argus Control Systems recommends a sensor in or near the canopy, with air drawn across it, as a practical stand-in for leaf conditions.
Enter both readings in °F or °C. The result is air VPD. To estimate what the leaf feels, add a leaf temperature offset: how many degrees warmer (+) or cooler (−) the leaf is than the air. An infrared thermometer pointed at a leaf gives you that number.
The formula
With temperature (T) in °C, the calculator works in three steps:
- Saturation vapor pressure, in kPa:
es = 0.6108 × exp(17.27 × T / (T + 237.3)) - Actual vapor pressure:
ea = es × RH / 100 VPD = es − ea
For leaf VPD, it calculates es at the leaf temperature and subtracts the same ea, because the air inside a leaf is treated as saturated at leaf temperature.
Worked example: 77°F (25°C) at 60% RH. es is 3.168 kPa, which matches FAO’s own figure for 25°C. ea is 3.168 × 0.60 = 1.901 kPa, so air VPD is 1.27 kPa. If the leaf is 2°C (3.6°F) cooler, es at 23°C is 2.809 kPa and leaf VPD is 0.91 kPa.
Some greenhouse controllers show VPD in millibars: 10 mb equals 1 kPa.
What VPD to aim for
There is no single correct VPD. Published figures are guidance for particular plants, not rules:
- American Orchid Society: about 0.5 to 1.2 kPa for many thin-leaved orchids. It treats air below roughly 0.4 kPa as overly wet, with high disease pressure, and above roughly 1.5 kPa as overly dry.
- Propagation and finishing: a fairly low VPD, around 0.3 kPa, while rooting cuttings, and above 0.5 kPa while finishing plants, figures the American Orchid Society attributes to Michigan State Extension.
- Argus Control Systems: uses 0.5 to 1.2 kPa as an example band, chosen for an imaginary crop, and notes that growers must set numbers for their own plants.
Reading the result
Low VPD (humid air). Transpiration slows. University of Arizona Extension notes that leaves stay wet longer, which favors fungal and bacterial diseases, and that at extremely low VPD, suppressed transpiration reduces nutrient movement inside the plant.
High VPD (dry air). The air pulls water out faster than roots can replace it, so plants close their stomata. That protects their water status but cuts carbon dioxide uptake, so photosynthesis and growth slow if it lasts.
Relative humidity alone can’t tell you which side you’re on. At 60% RH, VPD is about 0.7 kPa at 60°F but about 1.6 kPa at 85°F, more than twice the drying pull. What is VPD? explains why, and what to change when the number is off.
Sources
- Chapter 3 - Meteorological dataFood and Agriculture Organization of the United Nations (FAO Irrigation and Drainage Paper 56)
- Humidity and Vapor Pressure DeficitAmerican Orchid Society
- Understanding and Using VPDArgus Control Systems (application note)
- What the Air Is Telling You: Understanding Vapor Pressure Deficit and Why It Matters in Yuma AgricultureUniversity of Arizona Cooperative Extension
Estimates for general guidance, not professional advice for a specific plant or crop. Spot something wrong? Email info@terrathink.io.


